Membrane is a tile underlayment and uncoupling membrane.
Membrane can replace a second layer of plywood/concrete board and reduces the risk of tile cracks caused by movement in the flooring assembly. When integrated with Cable, the Membrane system is a best-in-class integrated uncoupling, waterproofing, and floor heating solution. Membrane eases the installation of Cable by simplifying the installation process.
Benefits
Reduces risk of tile cracks due to subfloor movement.Membrane is an uncoupling membrane which absorbs subfloor movements that can cause tiles to crack. Membrane received the highest 'Extra Heavy' result in Robinson Floor Test (ASTM C627). | |
Flexible wire spacing and heat outputCable provides the installer the ability to adjust the wire spacing and heat output according to installation needs. | |
Acts as tile underlaymentMembrane can replace plywood/concrete board as the tile underlayment in most tile installations. | |
Compatible with the Cable floor heating system.Membrane is specifically designed to accept the best-in-class Cable floor heating system. | |
Compatible with modified thinsets for tile setting.Tile/Stone floors can be installed on Membrane using modified and unmodified thinsets. | |
On-site flexibilityMembrane is cut on-site to fit the room. Cable is then installed into Membrane and adjusted on-site to provide heat coverage where it is desired. | |
Comprehensive selection of sizes to choose fromInstallers can choose from a variety of size options for Membrane: 161sqft rolls, 54sqft rolls, or 10sqft flat sheets. | |
Available immediately! |
Installation
1. Spread thinset mortar to the substrate using a trowel. | |
2. Roll Membrane onto the thinset mortar and press with a roller or a flat trowel. | |
3. Snap the Cable into the Membrane. | |
4. Using flat trowel, cover the membrane with thinset to ensure heating cable is encapsulated with thinset. | |
5. Install tile/stone flooring. |
See our recommended list of materials for planning your project.
Note:
1. Cable resistance must be tested before, during and after installation to validate nVent Nuheat warranties.
2. All wiring connections should be completed by a certified electrician.
Technical
Material | Membrane is a polypropylene sheet that is thermo-bonded to a non-woven polypropylene fabric on the underside. It is 0.22 inches thick, 39 inches wide and weighs 840 grams/m² |
Operating Voltage | 120 V, 208 V, and 240 V |
Power Output | 10 - 15 watts per square foot depending on wire spacing. Our recommended spacing is alternating 2-3-2 pillar spacing which produces 12 watts/sqft. If you are installing over a concrete slab and require more heat, we recommend using 2-pillar spacing which produces 15 watts/sqft. |
Maximum Continuous Exposure Temperature | 194°F (90°C) |
Heating Cable | 2-wire, grounded, twisted air with PVC outer jacket |
Cold Lead | 2-wire, 16-18 AWG plus ground braid layer; 10 ft (3m) length |
Downloads
Brochure | |
Product Fact Sheet | |
Data Sheet | |
Installation Guide |