The self-adhesive electric floor heating solution.
Mesh is an on-site adjustable "strip and roll" solution.
Mesh is best suited for square and rectangular shaped areas where some on-site flexibility is needed. The heating wire is attached to a roll of adhesive mesh material. During installation, the “roll” can be cut, turned, and adhered to the subfloor to provide floor heat in the desired areas of the room. Mesh kits comes in 32 sizes. Choose the mesh kit that is best suited for the size of the room/area and configure on-site to provide floor heat in the desired areas of the room.
Benefits
Easy to layout.Mesh comes in a self-adhesive roll which is pressed onto the subfloor and adjusted on-site to provide heat coverage where it is desired. | |
On-site flexibilityMembrane is cut on-site to fit the room. Cable is then installed into Membrane and adjusted on-site to provide heat coverage where it is desired. | |
Comprehensive selection of sizes to choose fromInstallers can choose from a variety of size options for Membrane: 161sqft rolls, 54sqft rolls, or 10sqft flat sheets. | |
Available immediately! |
Installation
1. Roll Mesh onto the subfloor with the wire side down. Start the mesh installation from one corner of the room. | |
2. Lay out and secure Mesh onto subfloor. To make a turn, cut the mesh as required (be careful not to cut/damage the heating wire). Separate heating wire from mesh to maintain heating coverage in small, angled, or difficult areas (if necessary). | |
3. Embed Mesh in mortar (self-leveling compound or latex-modified thinset). |
See our recommended list of materials for planning your project.
Note:
1. Cable resistance must be tested before, during and after installation to validate nVent Nuheat warranties.
2. All wiring connections should be completed by a certified electrician.
Technical
Material | Two single conductor Tefzel-coated resistance wires covered by a tin-plated copper braid and then coated with a durable copolymer (PVC) outer jacket. Heating cable is attached to a self-adhesive fiberglass mesh material |
Operating Voltage | 120 V and 240 V |
Power Output | 12 watts per square foot |
Maximum Continuous Exposure Temperature | 194°F (90°C) |
Heating Cable | 2-wire, grounded, twisted pair with PVC outer jacket |
Cold Lead | 2-wire, 16-18 AWG plus ground braid layer; 10 ft (3m) length |
Downloads
Brochure | |
Data Sheet | |
Installation Guide |