Standard Mats are the thinnest and easiest to install.
Standard Mats are only 1/8” thick and eliminates the need to configure the heating wires during installation. Standard Mats come in over 70 sizes of squares and rectangles of various dimensions. Simply pick the size of the mat(s) that fits the desired heating area. Because the heating wire is embedded in the Standard Mat and does not need to be configured during installation, the heat coverage is guaranteed to be consistent throughout the desired heating area.
Benefits
Easy to InstallStandard Mats are pre-built and ready to install right out of the box. The Standard Mat is simply adhered to the subfloor using thinset and flooring can be immediately installed on top. | |
Error-FreeStandard Mats eliminate the need to calculate and experiment with wire spacing during the installation. Consistent wire spacing and heat coverage is guaranteed. | |
Reduced installation timeStandard Mats shorten the installation process compared to cable and mesh systems because it eliminates the need to manipulate the heating product on site. | |
Does not raise floor heightStandard Mats guarantee minimal floor height increase. At 1/8" thick, the ultra low profile of this product reduces the build up on the floor which makes transitions possible without the use of transition strips. | |
Comprehensive selection of sizes availableStandard Mats are available in over 60 standard sizes in both 120 & 240 volt which provide optimal floor heating coverage in most standard areas. | |
Available immediately! |
Installation
1. Spread modified thinset onto subfloor using minimum 1/4" x 1/4" square notched trowel. | |
2. Place Standard Mat onto fresh thinset, press firmly to create 100% contact between Standard Mat, thinset and subfloor. | |
3. Secure floor sensor probe between heating wires. | |
4. Apply a thin layer of thinset and install tile/stone flooring as per manufacturer's instructions. |
See our recommended list of materials for planning your project.
Note:
1. Standard Mat resistance must be tested before, during and after installation to validate nVent Nuheat warranties.
2. All wiring connections should be completed by a certified electrician.
Technical
Material | Consists of a single-conductor tinned copper braided heating wire sandwiched in a pre-configured pattern between durable, two porous layers of fabric |
Operating Voltage | 120 V, 208 V, and 240 V |
Power Output | 12 watts per square foot |
Maximum Continuous Exposure Temperature | 194°F (90°C) |
Heating Cable | Single wire with ground braid outer layer |
Cold Lead | 2-wire, 18 AWG plus ground braid layer; 10 ft (3m) length |
Downloads
Brochure | |
Product Fact Sheet | |
Data Sheet | |
Installation Guide | |
Installation Instructions | |
Grid Paper Template |